top of page

Stern Thrust

Stern Thrust Boat Rear




Mounting only 80 mm below the waterline with only four screws

Power supply through a hole of only 60 mm in the ship's hull

Housing is made of solid aluminum, laminated and coated with antifouling

Electric motor in a protected and waterproof case

Double-sealed shaft

Electric motor with 160A/24V power supply

High efficiency due to flow-optimized geometry of housing

Installation at any point on the rear of the ship - no disturbing parts inside the ship

Perfect for aftercabin

Power transmission by stable stainless steel-impeller

Corrosion protection by two zinc anodes

Operation via joystick

Operating mode S2

Optional equipment:

Electronics for switching from 12V to 24V

bottom of page